Mike Kushy, Tim Rose and Sam Hill.
MK and TR to start with. Took in the materials and two drills. Left bang wire in situ and MK freed it from below the awkward climb, TR then coiled it up and left it in Boulder Chamber above. With the coast clear we took all the tools down cave. TR went to the sharp end and started sending rocks up and a couple of bags. With stacking looking dodgy MK then went through the connection and TR handed the rocks and bags through to him. SH then arrived. MK stayed where he was, TR sat at the top of the rope pull and SH went to the dig face. Many bags and rocks cleared. Over an hour of clearing and SH said it was about ready for drilling/banging. MK went to the front and cleared a few more bags and several rocks. In the mean time SH and TR cleared rocks further back in the Boulder Rift chamber. All hands on deck to pass drills and materials to the dig face. Couldn't drill any more than 600mm deep without hitting mud. 5 holes drilled, only 4 of these got used. 3 holes with 600mm of 40gm and 1 with about 400mm. TR headed out with drills and unwound the cable down the awkward climb. Charge went off fine. The draught at the dig face got stronger the more that was cleared. The Boulder Rift connection now draughts the opposite direction to when we first found it. Deep trench beyond a calcite ledge at the sharp end. 1-2 inch crack in the ceiling full of calcite heading off to the right. It's looking really wide at the end now, just need some working height. 4 1/2 hours for me. MK
 |
Current dig face after clearing. Photo MK.
|
 |
Skeleton in Boulder Rift. Photo SH.
|
 |
| Skeleton in Boulder Rift. Photo SH. |
No comments:
Post a Comment